H7 Plug & Play Load Resistor Set
Type of bulb: h7
Resistance: 6 ohm
maximum power: 50w
voltage: 12v
At the 13.5V voltage, the resistor generates a load 30.38W
Working temperature: -40 ° C to + 50 ° C
Attention! For Einparts Automotive LED bulbs, we are able to choose the right resistors. In case of doubt, please contact us.
resistor is a passive device generating an additional load, which is to eliminate problems with electronic checking whether the bulb is burned. Checking if the bulb is burned is made in 2 ways:
1. Checking the signal continuity - whether the current flows through the system (including the bulb)
2. Load check - if the load differs significantly from the standard computer, displays an error (this may take place when you install LED bulbs that take much less current than ordinary bulbs) - in this situation you should choose the appropriate resistor, which will help eliminate the load difference " burned bulb "(and other errors and messages of the on -board computer, e.g." no bulb ", blinking lights, disconnecting lights or incorrect frequency of direction indicators)
The system used in cars with CAN-Bus and Others.
Attention! The resistor must be installed on a metal element due to the possibility of heating.
Resistance: 6 ohm
maximum power: 50w
voltage: 12v
At the 13.5V voltage, the resistor generates a load 30.38W
Working temperature: -40 ° C to + 50 ° C
Attention! For Einparts Automotive LED bulbs, we are able to choose the right resistors. In case of doubt, please contact us.
resistor is a passive device generating an additional load, which is to eliminate problems with electronic checking whether the bulb is burned. Checking if the bulb is burned is made in 2 ways:
1. Checking the signal continuity - whether the current flows through the system (including the bulb)
2. Load check - if the load differs significantly from the standard computer, displays an error (this may take place when you install LED bulbs that take much less current than ordinary bulbs) - in this situation you should choose the appropriate resistor, which will help eliminate the load difference " burned bulb "(and other errors and messages of the on -board computer, e.g." no bulb ", blinking lights, disconnecting lights or incorrect frequency of direction indicators)
The system used in cars with CAN-Bus and Others.
Attention! The resistor must be installed on a metal element due to the possibility of heating.