Side Marker Flasher Control Unit (Makes your side markers flash with Indicators)

Fixing instructions:
1. One unit is required for each side of the vehicle.
2. Attach the flasher unit to a solid part of the vehicle, within the junction
box or close to the cables for the marker light feed, so that the unit can be
connected in line.
Wiring: This unit is rated at 1.0Amp. This is the maximum current draw that can be
applied by the side markers being made to flash.
If the current draw is higher, multiple flasher control units will be required.

Each unit is supplied with:
IN - 3 way AMP Superseal female, AMP282087-1
Pin 1 - Ground = WHITE
Pin 2 - Side marker = BLUE
Pin 3 - Indicator (YELLOW/BLACK)

OUT - 2 way AMP Superseal male, AMP282104-1
Pin 1 - Ground = WHITE
Pin 2 - Side marker = BLACK

To the IN connector, connect the flasher unit in-line on the marker light feed,
and take a wire from the indicator circuit on the same side of the vehicle and
connect to Pin 3 (YELLOW/BLACK).
From the OUT connector, link the GROUND and POSITIVE to the wires
feeding the marker lights. 

PM-5001 Side Marker Flasher Control Unit
12/24V operating voltage, 10-30Vdc range

3-core sheathed cable (power in) - terminated in 3-way AMP Superseal female connector2-core sheathed cable (power out) - terminated in 2-way AMP Superseal male connector LED or incandescent lamps

EMC
Directive
ECE R10:
This side marker flasher control unit has been approved to Automotive EMC
Directive ECE R10.05.0983
Good installation practice should be followed to ensure that compliance with
these directives is maintained, and a qualified electrician should be consulted.
Product
description
This product enables the vehicle side markers to flash synchronously with the
vehicle’s direction indicators when the indicators are activated. One unit is
required for each side of the vehicle.

AMP50 version includes rubber boots covering the connector/cable interface

EMC certified to ECE Reg 10.05

Designed for simplicity of installation

IP67 compliant